MOUNT VERNON, WA
Property maintenance in Mount Vernon.
Equipment assessments, rental turnovers, repairs and fall heating checks for property managers, landlords and agents in Mount Vernon and across Skagit County. One owner-operator — tested, not guessed.
Owner-operated
Tenant contacted same day
Appointment within 48 hrs
WA registered & insured
On every job
Your approval limit is respected
Anything over it waits for your OK.
Tenant scheduling handled
We coordinate access with the occupant.
Before-and-after photos
Proof of work to forward to the owner.
Itemized invoice
Line by line, with notes. No mystery charges.
SERVING MOUNT VERNON & NEARBY
Burlington
Sedro-Woolley
Anacortes
La Conner
Conway
SERVICES
The punch list, handled.
Specialty equipment work plus the everyday repairs that keep units rentable and listings sellable. We scope it, explain it and get approval before we start.
Equipment condition assessments
Tested and verified — never guessed.
Age decoded from serial numbers
Combustion, CO and airflow testing
Remaining-life estimate and report
HVAC equipment
Furnaces, heat pumps and mini-splits — measureQuick tested.
Clean, tune and diagnostics
Combustion analysis and CO checks
measureQuick report + Vitals score
Water heaters
Tank, tankless, gas and electric.
T&P valve testing and flushing
Venting and gas pressure review
Leak and corrosion assessment
Fireplaces & inserts
Gas fireplaces, inserts and stoves.
Annual service and cleaning
Pilot, ignition and gas pressure
CO testing at the room
Appliances
Diagnose, repair or advise.
Refrigerators, ranges and dishwashers
Washers, dryers and vent airflow
Repair-vs-replace guidance
CO & smoke alarm safety checks
Professional CO testing, alarms installed.
Room-by-room CO readings
Alarms tested, replaced or installed
Dated record for your files
Plumbing & electrical repairs
Fixed in-house, permits when required.
Faucets, toilets and drain leaks
Supply lines, valves and disposals
Outlets, GFCI, fixtures and fans
General repairs & handyman
Doors, cabinets, trim and drywall.
Doors, locks and weatherstripping
Cabinets, trim and drywall patches
Caulking, shelving and grab bars
Rental turnovers
Rent-ready between tenants.
Drywall patches and paint
Blinds, cabinets and hardware
Move-out punch lists
Pre-sale makeovers
List faster, sell for more.
Repairs, paint and touch-ups
Inspection repair items
Listing equipment sheet
Junk removal & cleanouts
Move-outs, estates and debris.
Tenant move-out cleanouts
Garage, shed and storage
Broom-clean finish
Sheds & gazebos
Build, assemble and install.
Kit assembly or custom builds
Site leveling and foundations
Roofing, doors and ramps
Doors, locks & windows
Secure, sealed and working.
Alignment, locksets and rekeys
Sliders, screens and closet doors
Window locks, blinds and seals
Drywall, paint & caulk
Patched and matched.
Patches, texture and repaints
Caulk and grout at tubs and sinks
Baseboard and trim repairs
Mounting & accessories
Level, anchored, done right.
Shelves, mirrors and TVs
Grab bars, towel bars and rods
Closet shelving and hardware
Rental condition reports
Move-in, move-out or periodic.
Room-by-room walkthrough
Every outlet and GFCI tested
Photos for every line item
Preventive maintenance
Small checks that prevent big calls.
Filter changes, sizes on file
Smoke and CO alarm upkeep
Dryer vents and washer hoses
Don’t see it listed?
Just ask.
Send a photo or short video
We’ll tell you if it’s our work
If not, we’ll point you to someone good
WHY A LOCAL VENDOR
Close by, and on your schedule.
Mount Vernon is home turf. That means shorter drives, faster scheduling and someone who knows the area’s housing and weather.
Short drive, fair trip charge
Based in Skagit County, so most Mount Vernon calls are close — your $80 trip charge goes further.
Built for local rentals
Single-family rentals, duplexes and small multifamily across Mount Vernon and Burlington.
Ready for the wet season
Fall heating checks, dryer vents and water heaters before the cold, damp months set in.
Listing-ready for agents
Equipment sheets for Skagit Valley listings, so buyers’ questions are answered up front.
OUR STANDARD
Tested, not guessed.
Nobody should estimate a furnace’s condition from the hallway. Every piece of equipment we assess is tested on site by a professional, using independent third-party instruments — and the readings go in your report.
Measured
Combustion analyzers, CO monitors, manometers and meters — logged live in measureQuick.
Verified
Checked against the manufacturer’s rated specs by a working professional.
Documented
Readings, rating-plate photos and dates — proof you can hand to anyone.

ABOUT
Hi, I’m Michael.
I started Tower Property Services because managers and owners deserve one dependable person for the work that keeps their properties running. I've lived in Skagit County for over 20 years, and I treat every unit like my name is on it — because it is.
I spent 10 years as an HVAC technician and have also worked as a carpenter, so I know homes inside and out — from the framing to the furnace.
Common questions
How do you know how old equipment is?
Most manufacturers encode the build date in the serial number. We decode it, photograph the rating plate, then measure how the unit is actually running.
Is an assessment the same as a home inspection?
No. It’s a focused condition assessment of mechanical equipment and appliances. It works alongside a licensed home inspection but doesn’t replace one.
Do you do plumbing and electrical?
Yes — everyday repairs like faucets, toilets, drains, fixtures, outlets and fans. If a job needs a permit or a specialty license, we’ll tell you up front and make sure it’s handled the right way.
What’s an approval limit?
The dollar amount we can spend on a job without checking with you first. Over that, we stop and call.
How do you price work?
An $80 trip charge covers the visit and the first 30 minutes. After that, each item is priced at fair market value — not by the hour. Larger jobs get a written quote first, and every job ends with an itemized invoice and photos.
How fast can you get out?
Routine requests are usually scheduled within a few business days, and urgent issues — active leaks, no heat, safety problems — go to the front of the line at the urgent rate. Tell us your move-in or closing date and we’ll plan around it.
REQUEST WORK
Submit a work order
Include the property address, tenant name and phone, the issue, photos if you have them, and your approval limit (NTE) — we’ll take it from there. You’ll hear back the same business day.
Prefer to talk it through? Call or text (360) 770-5391.
Scheduled maintenance and repairs — not a 24/7 emergency service. For active leaks or no heat, call.